RAID Array 450 HSZ50 HSOF Software Version 5.7 for Compaq Tru64 UNIX Release Notes

RAID Array 450 HSZ50 HSOF Software Version 5.7 for Compaq Tru64 UNIX

Page 36 AA–R1ZZE

−

Table 7-1 Patch Kits for Compaq Tru64 UNIX V4.0x

Compaq Tru64 UNIX Version Patch Kit

V4.0d 6

V4.0e 4

V4.0f 3

Please use your usual procedure to obtain the above listed patch kits.

NOTE

The correction in these patch kits is already present in Compaq

Tru64 UNIX V5.0 and higher.

7.3 CLEAR_ERRORS LOST_DATA command

When entering the CLEAR_ERRORS LOST_DATA command for a RAIDset-

based unit, always enter the command through the preferred path on the

controller that owns the unit. Entering the command form the companion

controller in a dual-redundant configuration does not clear the lost data.

7.4 Only One Switch per CLI Command Recommended

Certain switches within CLI commands are incompatible. To avoid problems,

specify only one switch per CLI command. For example, to set both

WRITEBACK_CACHE and NORUN on unit D102, use the following two

commands:

SET D102 WRITEBACK_CACHE

SET D102 NORUN

7.5 Hot Swapping Devices

When hot swapping a device, wait 90 seconds after you restore power before

enabling the bus, issuing CLI commands to the controller, or allowing any

activity to the controller.