RAID Array 410 HSZ40 HSOF Software Version 3.7 for Compaq Tru64 UNIX Release Notes

RAID Array 410 HSZ40 HSOF Software Version 3.7 for Compaq Tru64 UNIX
Page 46 AA–RMBXA − TE
8.3.3 C_SWAP Procedure
The procedure in the HSZ40 Array Controller HSOF Version 3.1 Service
Manual for restarting the subsystem after replacing a controller with C_SWAP
should contain the following note:
NOTE
The following error message is normal. Please continue with controller
configuration:
Other controller not responding – RESET signal
asserted.
8.3.4 Fault Management Utility Instance Codes
01192390—A processor interrupt was generated by the CACHE A Dynamic
Ram controller and ArBitration engine (DRAB) with an indication that the
CACHE backup battery has failed or is low (needs charging).
011A2390—A processor interrupt was generated by the CACHE B Dynamic
Ram controller and ArBitration engine (DRAB) with an indication that the
CACHE backup battery has failed or is low (needs charging).
42332080—Receive_main found destination address in the rcv packet does not
match node address.
010B2380—A processor interrupt was generated by the CACHEA Dynamic
Ram controller and ArBitration engine (DRAB) with an indication that the
CACHE backup battery has failed or is low (needs charging).
010C2380—A processor interrupt was generated by the CACHEB Dynamic
Ram controller and ArBitration engine (DRAB) with an indication that the
CACHE backup battery has failed or is low (needs charging).