HP Tru64 Unix Release Notes for Version 5.1B-6 (5900-1150)

or higher the snmpd script is replaced by the original version provided in the base version of the
Insight Management Agents kit.
It is recommended that any existing version of Tru64 UNIX Insight Management Agents kit
(CQPIMxxx kit, where xxx=310, 320, 370, and so on) be uninstalled prior to Version 5.1B-5 or
higher update and CPQIM370 kit with latest available CPQIM370 patches be re-installed after
5.1B-5 or higher update. The CPQIM kit is available at the site:
http://h30097.www3.hp.com/cma/.
The CPQIM patches are available at:
http:// h30097.www3.hp.com/cma/patches.html.
If you do not wish to perform the above mentioned step, the following steps will have to be
performed.
• You must restore the snmpd script to the latest version. To do this, create a backup file of
the snmpd script, and restore the backup version after installing V5.1B-5 or higher. (See step
1 of the workaround described in Some Insight Management Agents Kits Might Prevent
Version 5.1B-5 or Higher Installation).
• If you did not back up the snmpd file before installing V5.1B-6, you can modify the file after
the installation, as described in Some Insight Management Agents Kits Might Prevent Version
5.1B-5 or Higher Installation.
Stop sendmail Before Installing Kit
Stop the sendmail mailer daemon before installing this kit. Failing to do so can lead to the loss
of queued mail. Lost mail cannot be recovered.
To stop the daemon, enter the following command:
# /sbin/init.d/sendmail stop
Run Commands on BIND Systems After Kit Installation
After installing this kit on a system configured to be BIND server, run the following command:
# rcmgr set BIND_SERVERARGS "-c /etc/namedb/named.conf"
On a cluster configured to be a BIND server, run the following command:
# rcmgr -c set BIND_SERVERARGS "-c /etc/namedb/named.conf"
Stop the named daemon and restart it in order to have the new named daemon take effect:
• For standalone systems:
# /sbin/init.d/named stop
# /sbin/init.d/named start
• For clusters:
# /sbin/init.d/named cluster_stop
# /sbin/init.d/named start
To verify that your configuration files are compatible with Bind 9, run the following commands:
# named-checkconf /etc/namedb/named.conf
# named-checkzone example.com /etc/namedb/hosts.db
Installation Release Notes 17