RAID Array 410 HSZ40 HSOF Software Version 3.7 for Compaq Tru64 UNIX Release Notes

Release Notes
AA–RMBXA − TE Page 47
9.0 Software Installation
CAUTION
If you are operating with any Compaq Tru64 UNIX versions prior to
V5.0, it is important to install HSOF software V5.7 on your controllers
before upgrading to Compaq Tru64 UNIX versions 5.0 or higher.
This section provides the specific procedures needed to install your HSOF
V3.7 Software. The information in this section can be used in conjunction with
the information found in the HSZ40 Array Controller HSOF V3.1 Service
Manual, Chapter 3 “Installing and Upgrading “, pages 3-3 through 3-21.
Prior to installing HSOF V3.7 Software, please note the following:
CAUTION
If JBOD disks that were initialized using the
SAVE_CONFIGURATION switch on a HSZ40 controller running
HSOF Version 2.7 have been moved onto your HSZ40
controller, please contact your service representative before
upgrading your HSZ40 controller to HSOF Version 3.7
software.
The following section describes two types of controller upgrades:
• Single Controller Upgrade
• Dual-Redundant Controller Upgrade