HP Tru64 UNIX Release Notes for Version 5.1B-4 (13157)

You can correct this problem by installing the latest version of the Insight Manager, Version 3.6.
You can download this version from the HP Insight Management Agents for Tru64 UNIX Web
site:
http://h30097.www3.hp.com/cma/
If you have not installed Version 3.6 and the Insight Manager processes do not run after you
reboot your system, restart them using the Insight Manger startup scripts.
Autoloader Firmware Upgrade Changes WWID
A firmware upgrade to v1.50 or N14r on the 1x8 Autoloader causes the WWID to change. As a
result, the existing device associated with the media changer is no longer accessible. For complete
details see the Customer Advisory available at:
http://h30097.www3.hp.com/unix/erp/c00753663.html
Smart Array Booting Problem Might Require Service Call
If when booting your system you see a message similar to the following, rebooting your system
may be able to re-enable the hardware:
Smart Array at ciss(1) not responding - disabled.
If the reboot fails, call your HP service representative to have the unit repaired.
Do Not Use dxarchiver to Verify Bootable Tape
Do not use dxarchiver command to verify a bootable tape. Instead, use the mt and restore
commands as follows:
# mt fsf 1
# restore -i <device>
The first command skips the first file on the tape.
When preparing for a btcreate session, verify the size of the file system to ensure that you
have sufficient tape volumes, depending on the maximum storage capacity of your tape device.
The btcreate command prompts you to load a new tape volume if it runs out of storage space.
Label the tapes in sequence.
securenets File Requires localhost Entry
If the /var/yp/securenets file is in use as part of NIS, it must contain the following localhost
entry:
255.255.255.255 127.0.0.1
If the /var/yp/securenets file is used without a localhost entry, you will see severe delays
on logins. See ypserv(8) for more information.
SIA sialog Use Limitation Required
The Security Integration Architecture (SIA) sialog logging process is intended only for use in
debugging SIA problems. It should not be enabled for extended periods of time. Doing so can
cause login delays or other problems.
Use the audit , not the sialog process
, subsystem to monitor authentications on the system.
To disable sialog debug logging, delete the /var/adm/sialog file. For more information,
see the sialog(4) and sia_log(3) reference pages and the Tru64 UNIX Security Programming document.
General Release Notes 29