RAID Array 450 HSZ50 HSOF Software Version 5.7 for Compaq Tru64 UNIX Release Notes

Release Notes
AA–R1ZZE − TE Page 35
You have likely encountered this problem if the following occurs:
• You are attempting to do a firmware upgrade to a TZ87, TZ88, TZ89, or
any associated Automated Tape Library
• You are using program HSUTIL in the controller
• There is no tape in the target tape drive
• You receive a HSUTIL dialog similar to the following:
After you answer the next question, the code load will
start.
Do you want to continue (y/n) [n] ? y
HSUTIL is doing code load. Please be patient.
Error at PTL 3.4.0. Sense key:05 ASC/Q:24/8D.
The tape cartridge must be removed to update the tape
drive firmware.
The cartridge is in the drive. Please unload.
HSUTIL - Normal Termination at 03-APR-2000 14:36:06
The recommended work around is to use the built-in firmware upgrade
capability of the tape device itself. This is done by using a specially prepared
tape containing an image of the firmware upgrade code, and manipulating the
tape drive and/or Automated Tape Library loader controls to activate the built-
in firmware upgrade function of the tape drive or loader.
Please contact your service representative for further instructions on
performing this procedure.
7.2 Compaq Tru64 UNIX Patch Kits for Issue Resolution
As noted in Section 3.3, a rare issue related to Bad Block Replacements in data
transfers on mirrorsets is corrected by the application of both HSOF Software
V5.7 and a patch kit to Compaq Tru64 UNIX V4.0x operating systems. The
appropriate patch kit is identified in Table 7-1 below: