System information

7. If you need to replace the webcam module from the display enclosure, lift the webcam up to

disengage the adhesive tape that secures the webcam to the enclosure (1), and then disconnect

the webcam cable (2).

8. If you need to remove the display hinges, from each hinge remove the 3 Phillips PM 2.0x2.5

screws from the side of the hinge (1) and the 5 Phillips PM 2.5×2.5 broadhead screws from the

bottom of the hinge (2).

9. Remove the hinges from the display panel assembly (3).

Component replacement procedures