Specifications

To remove the processor:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 34).
2. Remove the stand (see
Stand on page 35).
3. Remove the right and left rear panels (see
Rear panels on page 47).
4. Remove the left cap (see
Left cap on page 61).
5. Remove the right cap (see
Right cap on page 67).
6. Remove the rear logo cover (see
Rear logo cover on page 72).
7. Remove the rear main frame (see
Main rear frame on page 75).
8. Remove the system board shield (see
System board shield on page 77).
9. Remove the fan sink (see
Fan sink (Thermal module) on page 85).
10. Rotate the locking lever to its full open position (1).
11. Lift the processor cover (2).
12. Carefully lift the processor from the socket (3).
CAUTION: Do NOT handle the pins in the processor socket. These pins are very fragile and
handling them could cause irreparable damage. Once pins are damaged it may be necessary to
replace the system board.
CAUTION: The heat sink must be installed within 24 hours of installing the processor to
prevent damage to the processor’s solder connections.
Figure 7-62 Removing the processor
Processor 87