Maintenance and Service Guide

Power connector and cable
Description Spare part number
Power connector and cable 592967-001
Before removing the power connector and cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3.
Disconnect the power cord.
4. Remove the battery (see
Battery on page 36).
5. Remove the following components:
a. Hard drive (see
Hard drive on page 38)
b. Top cover (see
Top cover on page 49)
c. Keyboard (see
Keyboard on page 51)
d. Display assembly (see
Display assembly on page 56)
e.
System board (see
System board on page 60)
Remove the power connector and cable:
1.
Turn the system board upside down, with the rear toward you.
2. Disconnect the power connector and cable from the system board.
64 Chapter 4 Removal and replacement procedures