User's Manual

Installing HP Device Manager
32 Configuring DHCP Servers
• Enter add optiondef 60 (name of your choice) STRING 0
then press the
Enter key.
• Enter set optionvalue 60 STRING “PXEClient“ then press
the
Enter key.
• To confirm that the settings are correct, enter show option-
value all then press the
Enter key.
3 Add option 201, and set the value to
“‘Management_Gateway_IP_Address’ ‘40003’“
• Type in add optiondef 201 (name of your choice) STRING
0 then press the
Enter key.
• Type in set optionvalue 201 STRING
‘Management_Gateway_IP_Address’ ‘40003’ then press
the
Enter key. (The Management_Gateway_IP_Address is
the address of the server running the Management Gateway
service.)
• To confirm that the settings are correct, type in show option-
value all then press the
Enter key.
Note: When setting optionvalue 201, ‘Management_Gateway_
IP_Address’ ‘40003’ must be written exactly as shown above,
including the single quotes and separated by a single space, other-
wise errors will occur.
The DHCP server should then be ready to be used with PXE.
Adding DHCP
Option 60 and 201
to an ISC DHCP
Server
If ISC DHCP server 2.0 is in use, it must be updated to ISC DHCP
server 3.0 as version 2.0 does not support vendor specific informa-
tion. For more information, see
HTTP://WWW.ISC.ORG.