Troubleshooting guide

Installing Thin Client Options
Various options can be installed on the thin client:
●
Installing the USB Device on page 12
●
Removing and Replacing the Battery on page 13
Installing the USB Device
Before beginning the replacement process, review General Hardware Installation Sequence
on page 7 for procedures you should follow before and after installing or replacing hardware.
▲
Insert the USB device into the USB port in the secure USB compartment. See the following
illustration for the location of the ports in the secure USB compartment.
Figure 2-6 USB ports in the secure USB compartment
If you install a USB mouse and a USB keyboard in the secure USB compartment, route the cables
around and through the clips, then out the secure cable routing slot, as shown in the following illustration.
Figure 2-7 Using the secure cable routing slot
12 Chapter 2 Hardware Changes