Hardware reference guide

Installing Thin Client Options
Various options can be installed on the thin client:
●
Installing the USB Device on page 16
●
Removing and Replacing the Battery on page 17
Installing the USB Device
Before beginning the replacement process, review General Hardware Installation Sequence
on page 11 for procedures you should follow before and after installing or replacing hardware.
▲
Insert the USB device into the USB port in the secure USB compartment. See the following
illustration for the location of the ports in the secure USB compartment.
Figure 2-6 USB ports in the secure USB compartment
If you install a USB mouse and a USB keyboard in the secure USB compartment, route the cables
around and through the clips, then out the secure cable routing slot, as shown in the following illustration.
Figure 2-7 Using the secure cable routing slot
16 Chapter 2 Hardware Changes