Specifications

Speaker
The speaker is attached to the front of the chassis under the rotating drive cage.
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 38).
2. Remove the access panel (
Access Panel on page 39).
3. Remove the front bezel (
Front Bezel on page 40).
4. Rotate the drive cage to its upright position.
5. Disconnect the speaker wire from the system board labeled SPKR (1).
6. Remove the screw that secures the speaker to the chassis (2).
7. Lift the speaker from the inside of the chassis to remove it (3).
Figure 5-32 Removing the speaker
To install the speaker, reverse the removal procedures.
Speaker 65