Specifications

3 Initial Terminal Setup
The Setup Wizard is used for initial setup of the terminal’s properties. The wizard
runs when:
• You power-up your terminal for the first time.
• An image has been downloaded to your terminal that is older than the image
currently in use.
• You use the Reset the Terminal to Factory-Default Property Settings
function on the General properties sheet, or you reset the terminal using a
hot-key procedure under direction of the factory.
Using the Setup Wizard
The Setup Wizard lets you set terminal network configuration and terminal display
parameters. Several dialog boxes display in succession during the process. Each
dialog box is self-explanatory. Some dialog boxes are informational and require no
user input. Other dialog boxes prompt you for network, printer, and display
information. See Figure 3-1 to view the Welcome/Countdown dialog box, which is
the first dialog box of the wizard.
Note
Any future changes to settings that were made using
the wizard can be made using the Terminal Properties
dialog box. Launch this dialog box from the
Connection Manager by pressing the F2 key. See
“Changing Terminal Properties.”