User Manual
If you encounter problems setting up the printer with optional equipment, contact your local service provider
or vendor for further assistance.
Set up the printer with a computer DSL/ADSL modem
If you have a DSL line and use that phone line to send faxes, follow these instructions to set up your fax.
1 Telephone wall jack.
2 Parallel splitter.
3 DSL/ADSL lter.
Connect one end of the phone jack that was supplied with the printer to connect to the 1-LINE port
on the back of the printer. Connect the other end of the cord to the DSL/ADSL lter.
You might need to connect the supplied phone cord to the adapter provided for your country/region.
4 Computer.
5 Computer DSL/ADSL modem.
NOTE: You need to purchase a parallel splitter. A parallel splitter has one RJ-11 port on the front and two
RJ-11 ports on the back. Do not use a 2–line phone splitter, a serial splitter, or a parallel splitter which has two
RJ-11 ports on the front and a plug on the back.
Figure 5-7 Example of a parallel splitter
To set up the printer with a computer DSL/ADSL modem
1. Obtain a DSL lter from your DSL provider.
2. Using the phone cord provided in the box with the printer, connect one end to the DSL lter, and then
connect the other end to the port labeled 1-LINE on the back of the printer.
NOTE: You might need to connect the supplied phone cord to the adapter provided for your country/
region.
If you do not use the supplied cord to connect from the DSL lter to the back of the printer, you might
not be able to fax successfully. This special phone cord is dierent from the phone cords you might
already have in your home or oice.
70 Chapter 5 Fax ENWW