Installation Manual

Installing SAN Manager LM

1. For Solaris 7 nodes only: Start up the node in 32-bit mode.

2. Log in as superuser.

3. Insert the SAN Manager LM CD-ROM in the CD drive.

By default, the CD-ROM mounts to the

/cdrom/sanman

directory.

If the CD does not mount automatically, enter the following command:

mount -F hsfs -o ro /vol/dev/dsk/c0t2d0 /cdrom/sanman

Note

Mount points may vary depending on your system configuration. In this

example, the CD drive is on controller 0, and c0t2d0 is the default CD-ROM

address.

4. Enter

pkgadd -d /cdrom/sanman

to add packages from the SAN Manager LM CD-

ROM.

A message similar to the following is displayed:

The following packages are available:

1 TRSANfcd Hewlett-Packard SAN Manager install set

(sparc) version 1.0.0

2 TRSANdoc SAN Manager documentation

(sparc) version 1.0.0

Select package(s) you wish to process (or 'all' to process all pack-

ages). (default: all) [?,??,q]:

5. To install the SAN Manager LM software and documentation, press

Return

. If you do

not want to install both packages, enter the number of the SAN Manager LM package to

install, and press

Return

6. When prompted to confirm the installation, enter

and press

Return