Instruction Manual
Table Of Contents
- G2 Backup System user guide
- Contents
- 1 Getting started
- 2 Home, Summary
- 3 Virtual Tape Devices
- 4 NAS
- 5 Appliance Configuration
- 6 Status
- 7 Replication
- 8 Administration
- 9 Restore processes with replication
- 10 Restore processes without replication
- 11 Understanding LEDs
- 12 Hardware monitoring
- 13 Troubleshooting
- Connecting to the StoreOnce Backup System from the backup application
- Connecting to the network
- Using the 10Gb ports (HP D2D4300 Series only)
- Performance
- Web Management Interface errors and warnings
- Power On/Off Problems
- Cannot connect to Web Management Interface
- NFS State handle error
- Cannot authenticate an iSCSI session
- Diagnostic Fibre Channel device
- If the HP StoreOnce Backup System runs out of disk space
- Cannot access a storage shelf (HP D2D4100 and 4300 Series Backup Systems)
- If backup or replication fails
- Recovering Devices that have ‘failed to start’ or have become read-only
- StoreOnce Backup System configuration problems
- Upgrade licenses
- Replacement of hardware
- Upgrades to component parts
- 14 Hard disk replacement
- A Extra information for G1 products
- Glossary
- About this guide
- Index
To apply the license key
1. Obtain the unique License to Use key, as instructed on the License Entitlement Certificate. This
is normally from the HP Licensing website at http://www.webware.hp.com. We recommend
that you select the option to save the license to a .DAT file. The file can also be emailed to
the registered license owner's email address or you can use Cut and Paste to copy it to a
temporary file.
2. Select the License page From the Web Management Interface to display a list of licensable
features.
3. Select the feature that you wish to license and click in the checkbox to enable it. If you have
saved the LTU as a .DAT file, click Upload license file and use the Browse option to locate the
file. If you used email or a temporary file, cut and paste the string exactly as you obtained it
from the HP Licensing website and click Enter LTU string. It is not advised to try and key in the
LTU manually. The key is specific to the HP StoreOnce Backup System and cannot be
transferred.
NOTE: If you are expanding the RAID disk capacity in an HP D2D4000 Series product, you will
be prompted to reboot your system.
License (Administration) 95