Instruction Manual
Table Of Contents
- G2 Backup System user guide
- Contents
- 1 Getting started
- 2 Home, Summary
- 3 Virtual Tape Devices
- 4 NAS
- 5 Appliance Configuration
- 6 Status
- 7 Replication
- 8 Administration
- 9 Restore processes with replication
- 10 Restore processes without replication
- 11 Understanding LEDs
- 12 Hardware monitoring
- 13 Troubleshooting
- Connecting to the StoreOnce Backup System from the backup application
- Connecting to the network
- Using the 10Gb ports (HP D2D4300 Series only)
- Performance
- Web Management Interface errors and warnings
- Power On/Off Problems
- Cannot connect to Web Management Interface
- NFS State handle error
- Cannot authenticate an iSCSI session
- Diagnostic Fibre Channel device
- If the HP StoreOnce Backup System runs out of disk space
- Cannot access a storage shelf (HP D2D4100 and 4300 Series Backup Systems)
- If backup or replication fails
- Recovering Devices that have ‘failed to start’ or have become read-only
- StoreOnce Backup System configuration problems
- Upgrade licenses
- Replacement of hardware
- Upgrades to component parts
- 14 Hard disk replacement
- A Extra information for G1 products
- Glossary
- About this guide
- Index
8 Administration
The Administration menu allows you to configure basic appliance settings, such as date and time
and licenses. The following options are available.
• User Account (Administration)
• Security (Administration)
• Date and Time (Administration)
• Housekeeping (Administration)
• Shutdown (Administration)
• Software (Administration)
• Support (Administration)
• Backup and Restore (Administration)
• License (Administration)
User Account (Administration)
This page allows you to manage the Administrator's password. It also includes sections for
configuring the amount of idle time before a user is automatically logged off and for
disabling/enabling the welcome message pop-up screen.
Password
When you first log on the Administrator user has a password of Admin. For security reasons, you
may wish to change this.
• Click Edit to make the fields editable.
• Make the required changes and click Update to apply the changes (or Cancel to discard them).
The new password must have at least 8 characters.
NOTE: The password that you configure on this page is also the password that is required when
accessing the HP StoreOnce Backup System configuration from the system console.
Resetting the password
If you forget your password, you can reset the HP StoreOnce Backup System as follows:
82 Administration