Instruction Manual

Table 23 Source Appliances parameters
This is the serial number of the source appliance. This information can be found by running
the Web Management Interface on the required appliance and looking at the Summary
page.
Serial Number
This is the name of the appliance for which you have specified the serial number and
cannot be altered.
Appliance Name
This is the status of the appliance for which you have specified the serial number and
cannot be altered.
Appliance Status
This is the address of the appliance for which you have specified the serial number and
cannot be altered.
Appliance Address
This checkbox indicates whether any mappings have been configured on the source
appliance. This is important to know, because any mappings that already exist will be
Configured Mappings
retained regardless of any access permissions you subsequently set up for libraries and
shares on that appliance.
To enable permissions
1. Select the source appliance in the list. There are two tabs; one for Libraries and one for Shares.
2. Click Edit. You can now check the Access box for those shares and libraries to which access
should be granted. These are the shares and libraries that will be displayed when the mapping
configuration step is run in the Replication wizard. It will not be possible to create a new share
or library from the wizard.
3. Click Update to apply the permissions.
Local Appliance (Replication)
This page contains three tabs that show general settings for the HP StoreOnce Backup System,
settings for blackout windows and bandwidth limiting settings. These are the tabs that allow you
to view and modify information about the appliance whose Web Management Interface you have
logged into.
Local Appliance (Replication) 77