Instruction Manual
Table Of Contents
- G2 Backup System user guide
- Contents
- 1 Getting started
- 2 Home, Summary
- 3 Virtual Tape Devices
- 4 NAS
- 5 Appliance Configuration
- 6 Status
- 7 Replication
- 8 Administration
- 9 Restore processes with replication
- 10 Restore processes without replication
- 11 Understanding LEDs
- 12 Hardware monitoring
- 13 Troubleshooting
- Connecting to the StoreOnce Backup System from the backup application
- Connecting to the network
- Using the 10Gb ports (HP D2D4300 Series only)
- Performance
- Web Management Interface errors and warnings
- Power On/Off Problems
- Cannot connect to Web Management Interface
- NFS State handle error
- Cannot authenticate an iSCSI session
- Diagnostic Fibre Channel device
- If the HP StoreOnce Backup System runs out of disk space
- Cannot access a storage shelf (HP D2D4100 and 4300 Series Backup Systems)
- If backup or replication fails
- Recovering Devices that have ‘failed to start’ or have become read-only
- StoreOnce Backup System configuration problems
- Upgrade licenses
- Replacement of hardware
- Upgrades to component parts
- 14 Hard disk replacement
- A Extra information for G1 products
- Glossary
- About this guide
- Index
7. The wizard then moves to the Select Target Library step. Select a library on the target appliance
and click Next.
NOTE: If you need to create a new library on the target appliance, click Create New Target
Library. Set up the details as you would normally do when creating a new library device.
When creating libraries on a target device it is possible to create libraries with 0 (zero) drives.
Attempting to create a library with more drives than those available on the target will fail with
a suggestion that there may be too many drives already in use on the target.
You cannot create a new target library if Source Appliance Permissions is enabled on the
selected target appliance. Instead the library must be first created on the target before mapping
from the source.
Virtual Tape Mappings (Replication) 63