Instruction Manual
Table Of Contents
- G2 Backup System user guide
- Contents
- 1 Getting started
- 2 Home, Summary
- 3 Virtual Tape Devices
- 4 NAS
- 5 Appliance Configuration
- 6 Status
- 7 Replication
- 8 Administration
- 9 Restore processes with replication
- 10 Restore processes without replication
- 11 Understanding LEDs
- 12 Hardware monitoring
- 13 Troubleshooting
- Connecting to the StoreOnce Backup System from the backup application
- Connecting to the network
- Using the 10Gb ports (HP D2D4300 Series only)
- Performance
- Web Management Interface errors and warnings
- Power On/Off Problems
- Cannot connect to Web Management Interface
- NFS State handle error
- Cannot authenticate an iSCSI session
- Diagnostic Fibre Channel device
- If the HP StoreOnce Backup System runs out of disk space
- Cannot access a storage shelf (HP D2D4100 and 4300 Series Backup Systems)
- If backup or replication fails
- Recovering Devices that have ‘failed to start’ or have become read-only
- StoreOnce Backup System configuration problems
- Upgrade licenses
- Replacement of hardware
- Upgrades to component parts
- 14 Hard disk replacement
- A Extra information for G1 products
- Glossary
- About this guide
- Index
5. Click Start Replication Wizard and proceed to the Select Target Appliance step.
TIP: Click on the show/hide details link to check how many target appliances are permitted
and the number of target appliances that are currently configured.
6. Select a Target Appliance from the list and click Next.
NOTE: If you want to select an appliance that is not yet on the list, click Add Target Appliance.
Enter the Target Appliance IP Address or fully qualified domain name. The default values for
the Command and Data Protocol Port Numbers are usually acceptable, but may be edited if
there is a conflict. (If replication needs to take place through a firewall, the network
administrator will need to open (TCP) ports 9387 (Command protocol) and 9388 (Data
protocol) to allow the replication traffic to pass to and from the HP StoreOnce Backup Systems.)
Click Add Target Appliance.
62 Replication