Instruction Manual
Table Of Contents
- G2 Backup System user guide
- Contents
- 1 Getting started
- 2 Home, Summary
- 3 Virtual Tape Devices
- 4 NAS
- 5 Appliance Configuration
- 6 Status
- 7 Replication
- 8 Administration
- 9 Restore processes with replication
- 10 Restore processes without replication
- 11 Understanding LEDs
- 12 Hardware monitoring
- 13 Troubleshooting
- Connecting to the StoreOnce Backup System from the backup application
- Connecting to the network
- Using the 10Gb ports (HP D2D4300 Series only)
- Performance
- Web Management Interface errors and warnings
- Power On/Off Problems
- Cannot connect to Web Management Interface
- NFS State handle error
- Cannot authenticate an iSCSI session
- Diagnostic Fibre Channel device
- If the HP StoreOnce Backup System runs out of disk space
- Cannot access a storage shelf (HP D2D4100 and 4300 Series Backup Systems)
- If backup or replication fails
- Recovering Devices that have ‘failed to start’ or have become read-only
- StoreOnce Backup System configuration problems
- Upgrade licenses
- Replacement of hardware
- Upgrades to component parts
- 14 Hard disk replacement
- A Extra information for G1 products
- Glossary
- About this guide
- Index
iSCSI (Status)
This page shows the iSCSI details for all the devices that are configured on the HP StoreOnce
Backup System. There are two tabs: Media Changer iSCSI details and Drive iSCSI Details. Click
on a device to select it and display the associated iSCSI information.
NOTE: There is also an Active Connections tab which displays information about open iSCSI
sessions. If all sessions are inactive (not connected), this tab is not displayed.
This page is mainly for information and is useful in troubleshooting. It cannot be edited.
If a device is showing as not connected, this indicates that the iSCSI Initiator on the host has not
logged on. Log on using the iSCSI Initiator and set the device as a Persistent Target for that host.
This ensures that it will automatically log on again whenever the host is rebooted.
Fibre Channel (Status)
This page shows the details for all the FC devices that are configured on the HP StoreOnce Backup
System. Select a library in the Devices list to view the connection details for the library's media
changer and drive(s).
This page is mainly for information and is useful in troubleshooting. It cannot be edited.
iSCSI (Status) 55