Instruction Manual
Table Of Contents
- G2 Backup System user guide
- Contents
- 1 Getting started
- 2 Home, Summary
- 3 Virtual Tape Devices
- 4 NAS
- 5 Appliance Configuration
- 6 Status
- 7 Replication
- 8 Administration
- 9 Restore processes with replication
- 10 Restore processes without replication
- 11 Understanding LEDs
- 12 Hardware monitoring
- 13 Troubleshooting
- Connecting to the StoreOnce Backup System from the backup application
- Connecting to the network
- Using the 10Gb ports (HP D2D4300 Series only)
- Performance
- Web Management Interface errors and warnings
- Power On/Off Problems
- Cannot connect to Web Management Interface
- NFS State handle error
- Cannot authenticate an iSCSI session
- Diagnostic Fibre Channel device
- If the HP StoreOnce Backup System runs out of disk space
- Cannot access a storage shelf (HP D2D4100 and 4300 Series Backup Systems)
- If backup or replication fails
- Recovering Devices that have ‘failed to start’ or have become read-only
- StoreOnce Backup System configuration problems
- Upgrade licenses
- Replacement of hardware
- Upgrades to component parts
- 14 Hard disk replacement
- A Extra information for G1 products
- Glossary
- About this guide
- Index
Manual jobs (Tape Attach)
This page provides a wizard that allows you to initiate an immediate import, export or copy
operation.
• A copy operation may be performed upon any non blank cartridge in any numbered slot in
a library device on the HP D2D Backup System. The cartridge data is copied from the HP
D2D Backup System to the physical tape storage device.
• An export operation may be performed upon any non blank cartridge in the mail slot in a
library device on the HP D2D Backup System. The cartridge data is first copied from the HP
D2D Backup System to the physical tape storage device and then subsequently deleted from
the HP D2D Backup System.
• An import operation may be performed on a physical cartridge in the attached tape drive.
The data is copied to the target device on the HP D2D Backup System. The operation will
automatically create a new cartridge in the mail slot of a library device.
NOTE: With SAS devices, up to four tape operations (import, export or copy) from separate
libraries may take place at any one time. If four jobs are already running concurrently, a warning
message will be displayed when you try to set up the new job. You must wait for one of the current
jobs to complete. With SCSI devices, the number of concurrent operations is limited to two.
There are two steps in this wizard:
Tape Attach 157