Instruction Manual
Table Of Contents
- G2 Backup System user guide
- Contents
- 1 Getting started
- 2 Home, Summary
- 3 Virtual Tape Devices
- 4 NAS
- 5 Appliance Configuration
- 6 Status
- 7 Replication
- 8 Administration
- 9 Restore processes with replication
- 10 Restore processes without replication
- 11 Understanding LEDs
- 12 Hardware monitoring
- 13 Troubleshooting
- Connecting to the StoreOnce Backup System from the backup application
- Connecting to the network
- Using the 10Gb ports (HP D2D4300 Series only)
- Performance
- Web Management Interface errors and warnings
- Power On/Off Problems
- Cannot connect to Web Management Interface
- NFS State handle error
- Cannot authenticate an iSCSI session
- Diagnostic Fibre Channel device
- If the HP StoreOnce Backup System runs out of disk space
- Cannot access a storage shelf (HP D2D4100 and 4300 Series Backup Systems)
- If backup or replication fails
- Recovering Devices that have ‘failed to start’ or have become read-only
- StoreOnce Backup System configuration problems
- Upgrade licenses
- Replacement of hardware
- Upgrades to component parts
- 14 Hard disk replacement
- A Extra information for G1 products
- Glossary
- About this guide
- Index
5. The information message advising you that the HP StoreOnce Backup System is optimizing is
normal and does not require you to take any action. The status will become OK as soon
optimization completes, but it may take some time. If you look at the Status—Storage page,
the same message is displayed but all relevant storage pool information is available.
Figure 54 Status—Storage page after storage is created
Creating cartridges (Virtual Tape Devices only)
All cartridges and data were lost when the disks failed. Before you can use the HP StoreOnce
Backup System you must create new cartridges. Use the Create all button to create a blank cartridge
of the size/emulation type selected when the library was first configured in all empty slots.
152 Hard disk replacement