Instruction Manual
Table Of Contents
- G2 Backup System user guide
- Contents
- 1 Getting started
- 2 Home, Summary
- 3 Virtual Tape Devices
- 4 NAS
- 5 Appliance Configuration
- 6 Status
- 7 Replication
- 8 Administration
- 9 Restore processes with replication
- 10 Restore processes without replication
- 11 Understanding LEDs
- 12 Hardware monitoring
- 13 Troubleshooting
- Connecting to the StoreOnce Backup System from the backup application
- Connecting to the network
- Using the 10Gb ports (HP D2D4300 Series only)
- Performance
- Web Management Interface errors and warnings
- Power On/Off Problems
- Cannot connect to Web Management Interface
- NFS State handle error
- Cannot authenticate an iSCSI session
- Diagnostic Fibre Channel device
- If the HP StoreOnce Backup System runs out of disk space
- Cannot access a storage shelf (HP D2D4100 and 4300 Series Backup Systems)
- If backup or replication fails
- Recovering Devices that have ‘failed to start’ or have become read-only
- StoreOnce Backup System configuration problems
- Upgrade licenses
- Replacement of hardware
- Upgrades to component parts
- 14 Hard disk replacement
- A Extra information for G1 products
- Glossary
- About this guide
- Index
Table 29 Location and Thermal Sensor ID values for HP D2D2500 Series and HP D2D4100 Series
Backup Systems (continued)
IDLocationIDLocationIDLocation
29SCSI_BACKPLANE_ZONE19System_BD9Memory_BD
30SCSI_BACKPLANE_ZONE20System_BD10Memory_BD
Table 30 Location and Thermal Sensor ID values for HP D2D4300 Series Backup Systems
IDLocationIDLocationIDLocation
21Processor_Zone11I/O_Zone1Ambient
22Pwr.Supply_Zone12I/O_Zone2CPU#1
23I/O_Zone13I/O_Zone3CPU#2
24I/O_Zone14I/O_Zone4Memory_BD
25System_board15I/O_Zone5Memory_BD
16I/O_Zone6System_BD
17I/O_Zone7System_BD
18I/O_Zone8Memory_BD
19I/O_Zone9Memory_BD
20I/O_Zone10I/O_ZONE
What events are reported for expansion shelves?
Table 31 Power Supply and Fan events for all expansion shelves (HP D2D2500 Series, HP D2D4100
Series and HP D2D4300 Series Backup Systems)
SNMP
Trap
Email
Alerts
Event
LogAlert levelMessageProblemComponent
YesYesYesCautionExternal Storage <Shelf Num> Power
Supply <ID> has failed or power
cable is disconnected
FailedPOWER SUPPLY
YesYesYesCautionExternal Storage <Shelf Num> Power
Supply <ID> removed
Removed
YesYesYesInformationExternal Storage <Shelf Num> Power
Supply <ID> inserted
Inserted
YesYesYesCautionExternal Storage <Shelf Num> Power
Supplies not redundant
Not Redundant
YesYesYesInformation(Message as above) ...repairedRepaired
YesYesYesCautionFan Failure <ID> <LOCATION>FailedFAN
YesYesYesCautionSystem Fan Removed <ID>
<LOCATION>
Removed
YesYesYesInformationSystem Fan inserted <ID>
<LOCATION>
Inserted
YesYesYesCautionSystem Fans not redundantNot Redundant
YesYesYesInformation(Message as above) ...repairedRepaired
124 Hardware monitoring