User's Guide

The OneCommand Manager User Manual Page 34
• If you want to add the host using default discovery methods, check Add using default
credentials and click Add Host. You will receive a message indicating whether the new
host was successfully added.
• If you want to add the new host using specific CIM credentials, check Add using spe-
cific CIM credentials, modify any additional CIM settings and click Add Host. The Add
Remote TCP/IP Host dialog box appears with default CIM settings.
Figure 13: Add Remote TCP/IP Host dialog box with CIM Credentials
4. Edit the default CIM settings if necessary and click Add Host. You will receive a message
indicating the new host was successfully added.
Adding a Range of Hosts
You find the TCP/IP-accessed manageable hosts by searching a range of IP addresses. The Add Range
of TCP/IP Hosts dialog box enables you to build the initial list of TCP/IP accessed manageable hosts.
(Not available in read-only mode.)
Note: CIM clients are only supported on Windows remote GUI OneCommand Manager
systems.
Note: The ranges of IP addresses are only scanned each time you open the Add Remote
TCP/IP Hosts dialog box and click Start Discovery. The ranges are NOT
automatically scanned by the discovery server during its discovery cycles.
Note: CIM is only supported on Windows systems.
Note: Adding a range of hosts is only supported for IPv4 addresses. It is not supported for
IPv6 addresses.