User's Guide

The OneCommand Manager User Manual Page 30
2. Choose the management type and read-only mode you want.
3. Click OK.
In Solaris
1. Run the following script:
/opt/ELXocm/set_operating_mode
2. Choose the management type and read-only mode you want.
In Linux
1. Stop the OneCommand Manager application.
2. Run the following script:
/usr/sbin/ocmanager/set_operating_mode
3. Choose the management type and read-only mode you want.
Configuring Discovery
Automatic FC Discovery
Adapters that have a physical FC connection to the same SAN are discovered automatically when the
OneCommand Manager application is launched. Adapters that do not have a physical FC connection to
the SAN, where the OneCommand Manager application is launched, can be discovered by sending
management requests to the remote host using TCP/IP.
Note: The OneCommand Manager application can only discover and manage remote
adapters on hosts running the OneCommand Manager application’s remote
management server. Remote FC capabilities of the OneCommand Manager
application are subject to fabric zoning. Hosts you want to discover and manage
using the OneCommand Manager application must be in the same zone or
discovered and managed through TCP/IP access.
Note: After adding an adapter to a running Windows system (commonly called a hot plug),
click Discovery Refresh ( ) or reconnect to the discovery server to display the new
adapter port in the discovery-tree. Hot plug is only supported by the OneCommand
Manager application on Windows platforms.