User's Guide

The OneCommand Manager User Manual Page 19
In Solaris
Prerequisites
• The Solaris FC/FCoE driver version 2.60 or later must be installed for FC/FCoE management.
• The NIC driver version 1.20 or later must be installed for UCNA management.
Procedures
To install the OneCommand Manager application CLI:
1. Copy the OneCommand Manager application core kit to a temporary directory on the system.
2. Untar the core kit. Type:
tar xvf elxocmcore-<kit version>.tar
3. Change to the newly created elxocmcore-<kit version> directory:
cd ./elxocmcore-<kit version>/
4. Run the install script and follow the instructions.
./install
If the HBAnyware utility, the OneCommand Manager application core kit, the OneCommand
Manager application enterprise kit, or the Solaris driver utilities are already present on the sys-
tem, the install script attempts to first remove them.
Upgrading from the OneCommand Manager Application CLI to the Full-
Featured OneCommand Manager Application Enterprise Kit
In Windows
To upgrade from the OneCommand Manager application CLI to the full-featured OneCommand Manager
application kit:
1. From the desktop, run the elxocm-windows-<kit version>.exe file that contains the full
application kit.
Running this executable file removes the OneCommand Manager application CLI and installs a
full-featured version of the OneCommand Manager application that includes the CLI and the
GUI.
Note: If Emulex OneConnect UCNAs are installed on the system, the NIC driver must be
installed and reporting all NIC ports. Otherwise, the OneCommand Manager
application cannot manage UCNAs.
Note: An upgrade can be performed only if the version of the OneCommand Manager
application enterprise kit is the same or later than the OneCommand Manager
application CLI version. You cannot downgrade a OneCommand Manager application
CLI with a previous version of the OneCommand Manager application enterprise kit.
Note: When the OneCommand Vision Sensor software is installed on production servers
with Emulex adapters installed, the Sensor software may load and use some of the
software components included in the OneCommand Manager application or
HBAnyware utility software stacks. It is essential that the OneCommand Vision
Sensor software be stopped before performing any upgrades, or updates, to the
OneCommand Manager application or HBAnyware software stack components. For
information on stopping the Sensor, refer the OneCommand Vision user manual.