User's Guide

The OneCommand Manager User Manual Page 250
Reset
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd Reset <WWPN>
Description: This command resets the adapter. An adapter reset can require several seconds to
complete, especially for remote devices. When the reset is completed, the system command prompt is
displayed.
Parameters:
WWPN - Adapter’s WWPN
SetCimCred
Supported by: VMware
Syntax:
hbacmd SetCimCred <username> <password> <namespace> <portnum>
Description: This command sets the default CIM credentials. You must specify all four credentials:
username, password, namespace and portnumber. Default credentials are used if any credential is not
in the hbacmd command argument. Once the default credentials for a host are set, any other command
can be issued by specifying m=cim.
Parameters:
h - Port’s IP Address
m - cim
username - root - Login User ID of the VMware ESX
password - Login password of the VMware ESX
namespace - Namespace where the Emulex provider is registered in the sfcb CIMOM of
VMware ESX, specifically root/emulex
portnum - Port number of the sfcb CIMOM listening to that is, 5988 (HTTP) or 5989 (HTTPS)
Note: Supported only for FC and FCoE ports. Not supported for NIC and iSCSI ports.
Note: For OneConnect FCoE ports, this command only resets the driver to update
changed driver parameters that require a driver reset. It does not cause a hardware
reset of the adapter port.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 250.
Note: Use this command to set only the CIM credentials. Once this is done,
subsequent hbacmd commands do not require you to specify the CIM credentials in
the command line.