User's Guide

The OneCommand Manager User Manual Page 249
ListHBAs
Supported by: Windows, Solaris, Linux and VMware ESX
Description: This command shows a list of the manageable Emulex adapters found by local, remote in-
band (FC), and remote out-of-band (TCP/IP) discovery. For a NIC-only or iSCSI adapter, the MAC
address is displayed rather than the Port WWN. The Node WWN and Fabric WWN are not displayed.
The type of information listed may vary according to the adapter model.
Syntax:
hbacmd [h=<IPAddress>] listhbas [local] [m=model] [pt=type]
Parameters:
h - Host’s IP address
local - Only display local adapters
m=model - Model filter (append * to end of model name for wildcard match, e.g. LP9*)
pt=type - Port type filter (valid types: NIC, iSCSI, FC, FCoE)
RemoveHost
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd RemoveHost host_address
Description: This command removes a host from the hosts file use for TCP/IP management in the
OneCommand Manager application GUI. The host_address can be an IP address, using the IPv4 or
IPv6 format, or a host name.
Parameters:
host_address - Host to remove
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 250.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 250.