User's Guide

The OneCommand Manager User Manual Page 247
ExportSANInfo
Supported by: Windows, Solaris Linux and VMware ESX
Syntax:
hbacmd ExportSANInfo [format]
Description: For reporting purposes, this command captures the SAN information in xml or csv format.
As large amount of information is output from this command Emulex recommends that you re-direct the
output to a file.
Parameters:
Format:
csv - Output information in CSV format
xml - Output information in XML format (default)
GetCimCred
Supported by: Windows
Syntax:
hbacmd GetCimCred
Description: This command shows the default credentials set for the CIM client.
Parameters: None
Note: For OneConnect and 16-Gb HBA adapters, while the WWPN or MAC address
is used to identify the adapter, the updated firmware applies to all ports on that
adapter. It is not necessary to download the firmware on all the adapter ports of a
OneConnect adapter or a 16-Gb HBA adapter.
Note: Emulex recommends that you redirect this output to a file with proper
extension, '.xml' for XML-formatted files and '.csv' for CSV-formatted files.
Note: Due to the amount of information that must be obtained and reported, this
command can take a long time on large SAN configurations.
Note: [format] is optional. If the format parameter is specified as csv, adapter
information is shown in csv format. If the format parameter is specified as xml,
adapter information is shown in xml format. Leaving the format parameter blank
shows the data in xml format.
Note: The password is encrypted.