User's Guide

The OneCommand Manager User Manual Page 225
Parameters:
WWPN - Adapter’s WWPN
MAC - MAC address of the CNA port
SetRetentionCount
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd SetRetentionCount <WWPN|MAC> <Value>
Description: This command specifies the maximum number of diagnostic dump files for the adapter.
When the count reaches the limit, the next dump operation deletes the oldest file.
Parameters:
WWPN - Adapter’s WWPN
MAC - MAC address of the CNA port
Value - The number of dump files to retain
Example:
hbacmd h=10.192.193.154 m=cim u=root p=Swamiji001 n=root/emulex
SetRetentionCount 00-00-c9-93-2f-9f 6
FCoE Commands
GetFCFInfo
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd GetFCFInfo <WWPN>
Description: This command shows the FCF information of the OneConnect adapter in FCoE mode.
Parameters:
WWPN - Adapter’s WWPN
Example
# hbacmd getfcfinfo 10:00:00:00:c9:3c:f7:88
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 250.
Note: The retention count applies to all adapters in the server.
Note: These commands are supported only on OneConnect FCoE ports.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 250.