User's Guide

The OneCommand Manager User Manual Page 208
Data Center Bridging Commands
GetDCBParams
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd GetDCBParams <WWPN|MAC>
Description: This command shows the Internal Host PFC flag value and DCBX mode ( DCB version),
as well as, the LLDP state for iSCSI, FCoE and NIC CNAs.
Parameters:
WWPN - Adapter’s WWPN
MAC - MAC address of the NIC or iSCSI port
Example:
hbacmd h=10.192.203.154 getdcbparams 00-00-c9-93-2f-d8
GetPGInfo
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd GetPGInfo <WWPN|MAC>
Description: This command shows the bandwidth percentages for all the priority groups for the port.
Additionally, this command displays the number of priority groups supported by an adapter.
Parameters:
WWPN - The WWPN address of the FCoE port
MAC - MAC address of the NIC or iSCSI port
Example:
hbacmd h=10.192.203.154 getpginfo 00-00-c9-93-2f-d8
Note: Data Center Bridging (DCB) commands are for DCB management of
OneConnect adapters only.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 250.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 250.