User's Guide

The OneCommand Manager User Manual Page 204
Npt - New password type:
1 = ASCII
2 = Hex (binary)
Npw - New password value
Boot Commands
EnableBootCode
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd EnableBootCode <WWPN|MAC> <Flag>
Description: This command enables or disables the boot code on the FC adapter or the Preboot
Execution Environment (PXE) BIOS of the NIC on the CNA adapter. If the boot code is disabled on the
FC adapter, the adapter does not boot from the SAN, regardless of the value for the
EnableBootFromSan boot param. If the boot code is enabled on the FC adapter, the adapter boots from
the SAN if the EnableBootFromSan parameter is also enabled. Disabling the PXE BIOS on the CNA
adapter's NIC prevents booting from the NIC. Enabling the PXE BIOS on the CNA adapter's NIC allows
booting from the NIC.
Parameters:
WWPN - Adapter’s WWPN
MAC - The MAC address of the NIC or iSCSI port
Flag -
D = Disable the boot code
E = Enable the boot code
GetBootParams
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd GetBootParams <WWPN> <Type>
Description: This command shows the boot parameters. If any arguments are missing or invalid, a
suitable error is reported. If all arguments are correct, the data is displayed in tabular form.
Parameters:
WWPN - Adapter’s WWPN
Note: Boot commands are supported on FC/FCoE adapter ports only.
Note: This command is not supported for OneConnect adapters. The boot code is
always enabled on OneConnect adapters.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 250.