User's Guide

The OneCommand Manager User Manual Page 200
Parameters:
WWPN - Adapter’s WWPN
PfcThrottle state-
0 for Disable
1 for Enable
SetPortEnabled
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd SetPortEnabled <WWPN|MAC> <PortEnable>
Description: This command enables or disables the FC or CNA port.
Parameters:
WWPN - Adapter’s WWPN
MAC - MAC address of the NIC or iSCSI port
PortEnable -
0 for Disable
1 for Enable
SetPhyPortSpeed
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd SetPhyPortSpeed <WWPN|MAC> <Mode> [Speed [Length]]
Description: This command sets the port speed on OneConnect OCe11102 adapters.
Parameters:
WWPN - Adapter’s WWPN
MAC - MAC address of the NIC port
Mode - Mode number
0 for Default
1 for Auto-Negotiate
2 for Force
Note: Ensure all I/O on the port is stopped, before disabling the port.
Note: When the SetPortEnabled command disables an FC port, the adapter must be
reset to activate the new setting. Only OneConnect™ adapters do not require a reset
when the adapter port is enabled or disabled.
Note: The SetPhyPortSpeed command is available in OneConnect OCe11102
adapters only.