User's Guide

The OneCommand Manager User Manual Page 10
8. Run the install script. Type:
./install.sh
9. When promted, choose whether or not to install the OneCommand Vision Sensor:
Would you like to install the OneCommand Vision Sensor kits along with
this installation?
Enter y to install the kit.
Enter n not to install the kit. (default)
Enter the letter 'y' or 'n' y
10. When prompted, enter the type of management you want to use:
Enter the type of management you want to use:
1 Local Mode : HBA's on this Platform can be managed by OneCommand
clients on this Platform Only.
2 Managed Mode: HBA's on this Platform can be managed by local or
remote OneCommand clients.
3 Remote Mode : Same as '2' plus OneCommand clients on this Platform
can manage local and remote HBA's.
4 Management Host : Same as '1' plus OneCommand clients on this Platform
can manage remote HBA's.
If you select option 2, you are asked if you want to enable TCP/IP management from remote
hosts.
If you select option 3, you are asked if you want to enable TCP/IP management of/from remote
hosts. You are prompted to enter the TCP/IP port number to use. (Leaving the field blank
defaults to 23333.)
If you select options 2 or 3, you are prompted for the management host address. (Leaving the
field blanks means none.)
You can enter an IP address or host name. If you enter a management host address, you will be
prompted to exclude management of this host from any other host.
If you select option 4, management of remote hosts is automatically selected and you are
prompted to enter the TCP/IP port number to use. (Leaving the field blank defaults to 23333.)
11. If you answered 2, 3 or 4 in step 5, you must decide if you want the OneCommand Manager
application to operate in read-only mode. Read-only mode prevents users from performing
certain operations such as resetting adapters, updating an adapter's firmware and changing
adapter driver properties and bindings. It only affects the local OneCommand Manager
application interface. These operations can still be performed using remote management. Enter
<y> for yes to allow the user to perform these operations, enter <n> for no if read-only mode is
desired.
12. You are prompted about allowing users to change the management mode after installation.
Enter <y> for yes, or <n> for no.
In VMware ESX Server
For the best real-time management of Emulex adapters in VMware ESX and ESXi environments, the
OneCommand Manager for VMware vCenter software plug-in (OCM for VMware) is highly
recommended. For more information and to download go to
http://www.emulex.com/products/software-solutions/device-management/onecommand-manager-for-
vmware/overview.html.
The following must be installed before you can install the OneCommand Manager application:
Note: Management hosts cannot be managed by remote hosts