User guide

See “Verification test functions” (page 142) for more specific information about each sub-test.
Verification test functions
To run tests and review results, use the Verification Tests window, shown in Figure 19 (page 142).
To display the window, select Tools→Library Diagnostics→Verification Tests.
Figure 19 Verification tests window
Library alignment test
The library alignment test performs the following tasks:
• Performs accessor X-axis and Y-axis travel test (also calls the FRU accessor assembly test)
• Calibrates library and checks calibration offsets by comparing them to the default values for
the drives and I/E stations
• Checks magazine offsets
• Checks collected offset alignments for magazines, I/E stations, and drive sleds
• Checks joint alignment quality
142 Maintaining the library