Instruction Manual

6. Click OK to save the settings and close the Preferences dialog box.
Or, click Apply to save the settings without closing the Preferences dialog box.
7. Because you made system configuration changes, you must click Yes to save the configuration
changes For more information, see Saving and Restoring Library Configuration.
About the configuration record
Before using the Setup Wizard, see Setup Wizard Prerequisites.
The configuration record contains details about the library configuration and can be sent to a specified
e-mail address or saved as a .txt file.
Information in the configuration record includes:
• Product information: Product name and version, MCB and RCU versions, serial number, and
modules/drives/partitions configuration
• License information: License descriptions, quantities, and installation dates
• Partition information: Serial numbers, online/offline statuses, and numbers of slots, drives, and
I/E slots
• Network information: Hostname, DHCP status, IP address, and IP, Netmask, and Gateway addresses
• Drive information, for each drive: Location, partition, online/offline status, vendor, model, serial
number, logical serial number, firmware version, drive type, and interface type:
• Fibre Channel (FC) tape drives — World Wide Name (WWN) and loop ID, speed, and connection
type
Before you can e-mail the configuration record, the library e-mail account must be configured. For
information on configuring the library e-mail account, see Configuring E-mail.
Setting aisle lights
Before using the Setup Wizard, see Setup Wizard Prerequisites.
Aisle lights are optional on each module, and are mounted to the roof of each module to illuminate
the inside of the library.
To set the duration for aisle lighting:
1. From the main console, select Setup > Library Settings > Aisle Light Settings.
The Aisle Light Settings dialog box appears.
2. Select a duration for the light to illuminate: 30 minutes, 1 hour, or Always Off.
3. Click OK.
Modifying the Library Configuration84