Instruction Manual

Figure 18 Coordinates in Media Status dialog box
.
Tape Drive Locations
The location coordinates of a drive are based on the position of the drive in the module and section.
Tape drives are always in rack 1, column 1, of a particular module.
Columns are read from left to right as you face the rack.
Because all drives in the library are full-height drives, each drive is in row 1 of the designated
section.
The library can accommodate 2 drive clusters per rack with each drive cluster containing up to 6
drives.
Drive number 1 is in the lowest section of the lower drive cluster. Drives are numbered from bottom
to top. Figure 19 shows the physical location of drive 9. Compare with Table 13.
Operating the Library106