User's Manual
HP StorageWorks File System Extender Software user guide 63
TIP: You can also check the /proc/scsi/scsi file for a list of available SCSI devices.
Windows specific
The next steps depend on the chosen FSE user interface.
To configure an FSE library and an FSE drive using the FSE command-line interface, proceed with the
following steps:
2. Locate the directory with the FSE configuration templates.
Linux specific
On the Linux platform, the full pathname of the directory with FSE configuration templates is
/opt/fse/newconfig.
Windows specific
On the Windows platform, the full pathname of the directory with FSE configuration templates is
%InstallPath%\newconfig. The value of %InstallPath% depends on the choice made in the
FSE installation process. It defaults to C:\Program Files\Hewlett-Packard\FSE.
3. Make local copies of the FSE library configuration template and the FSE drive configuration template.
The respective templates are named fse-library.cfg and fse-drive.cfg.
4. Edit the local copies of the FSE library configuration file template and the FSE drive configuration file
template, and configure the appropriate parameter values. Use the values you obtained in step 1 and
verify that all other parameters match the characteristics of your tape library and tape drive.
For an FSE library, you need to configure the following parameters in its configuration file:
• Name
• Host
• ControlDevice
• LibType
• MediaFamily
• Slots
For an FSE drive, you need to configure the following parameters in its configuration file:
• Name
• Library
• MediaFamily
C:\Program Files\Hewlett-Packard\FSE\bin>fse_scsi --scan
** \\.\Scsi0: id:0:0:2:0
SCSI device ID: port 0, ch 0, id 0, lun 0, type Medium Changer 8
Device: HP MSL6000 Series 0430 ser #:3G2BLBD358D0 std :2
** \\.\Scsi1: id:1:0:2:0
SCSI device ID: port 1, ch 0, id 0, lun 0, type Tape 1
Device: HP Ultrium 2-SCSI F59W ser #:HUL2K00119 std :3
Done!