User's Manual

HP StorageWorks File System Extender Software user guide 203
IMPORTANT: In the general configuration file, the lines with configured parameters must not contain
leading spaces.
ProcessFileFromBeginning Analysis mode:
0 = analyze only the newly-added log messages (default)
1 = analyze the entire log file (for debug purpose)
IgnoreCase Case sensitivity of the regular expressions in the rules files:
0 = regular expressions are case sensitive (default)
1 = ignore case in regular expressions
ServerName Name or IP address of the SMTP server
UseSMTPAuthentication Authentication mode:
0 = disables authentication (default)
1 = enables authentication
If SMTP authentication is enabled, the following parameters are also required:
username
password
MailText The text contained in the mail. If the text consists of several lines, the lines must
start with blanks.
Subject E-mail subject
SubjectPrefix The text placed in front of the subject of the MailCurrentLogMessage
action. For more information on the MailCurrentLogMessage action, see
section ”
The rules configuration file” on page 204.
From Sender e-mail address
To One or more receiver e-mail addresses delimited by spaces
AttachmentPrefix Prefix of the analysis results file. The format of the analysis results filename is
as follows:
AttachmentPrefix_YYMMDD_HHMMSS.log.zip
Such a naming convention ensures that the analysis results files sent to
receivers are not overwritten.
ZipAttachment Compression mode:
0 = disables the compression of attachments
1 = enables the compression of attachments (default)
Slot Message packages (all filtered log messages) dispatch or dump interval in
minutes
DestinationIP The IP address of the SNMP server
CommunityName A name used to group SNMP hosts. By default, all hosts belong to the public
community, which is the standard name for the common community of all
SNMP hosts.
SenderOID Object ID (OID) of the sender system. The OID for FSE is
1.3.6.1.4.1.18945.1.1.0.
Parameter Description