User's Manual

156 Monitoring and maintaining FSE
2. On the FSE server system, run the following command:
Retrieving detailed information about configured FSE partitions
To retrieve detailed information about configured FSE partitions using the FSE command-line interface, run
the following command:
An example of this command output is shown in ”Excerpt from an example output of the fsepartition --list
--detail command” on page 173.
To retrieve detailed information about a configured FSE partition using graphical user interface, in the FSE
Management Console window, in the object tree, expand the Partitions container, and select the desired
FSE partition. The retrieved details will be displayed on a property page in the right pane.
Figure 30 Retrieving detailed information for an FSE partition
NOTE: The set of partition properties that is retrieved using FSE command-line interface differs from the
set that is retrieved using the FSE Management Console.
Switching the access mode for an HSM file system
The fse command provides special options that allow you to manually switch between Limited Access
Mode (LAM) and Full Access Mode (FAM) for a particular HSM file system on a Windows FSE client.
Limitations
• Limited Access Mode and emergency situations
LAM was designed to provide access to online files in emergency situations, for example, if the FSE
system cannot be started, the blocked Hierarchical Storage Manager (HSM) process cannot be
terminated, and similar exceptional circumstances. Usually, you should avoid switching manually
between HSM file system access modes, so only consider using the fse --limit-access
command in the cases mentioned above.
• Limited Access Mode and the fsefile --recall command
fsepartition --remove PartitionName
fsepartition --list --detail