Installation Manual

58 Upgrading from previous FSE releases
If you are upgrading an FSE server, invoke the following commands:
In both cases, the second rpm command installs the FSE utilities: HSM Health Monitor and Log
Analyzer.
If you are upgrading the FSE release 3.4 with an FSE system maintenance release or an FSE hot fix for this
release, perform the following procedure to appropriately install the software on the consolidated FSE
system or FSE server:
• At the command line, change the current directory to the one with the installation packages. Install all
required FSE system maintenance release or FSE hot fix RPM packages with one invocation of the rpm
command.
If you are upgrading a consolidated FSE system, invoke the following command:
If you are upgrading an FSE server, invoke the following command:
Starting up the FSE server
On the consolidated FSE system or the FSE server, you need to start the FSE processes. Depending on the
type of the FSE host, you may need to perform additional steps after the startup. These steps are required
because of a changed format of the FileSystemID parameter in the FSE partition configuration files.
Follow the procedure:
1. Run the fse --start command to start omniNames (CORBA Naming Service daemon) and the FSE
server processes:
Consolidated FSE system
FSE server
# rpm -Fvh fse-common-3.4.0* fse-server-3.4.0* fse-agent-3.4.0* \
fse-cli-admin-3.4.0*
# rpm -ivh fse-util-3.4.0*
# rpm -Fvh fse-common-3.4.SMRNumber* fse-server-3.4.SMRNumber* \
fse-agent-3.4.SMRNumber* fse-client-3.4.SMRNumber* \
fse-cli-admin-3.4.SMRNumber* fse-cli-user-3.4.SMRNumber* \
fse-util-3.4.SMRNumber*
# rpm -Fvh fse-common-3.4.SMRNumber* fse-server-3.4.SMRNumber* \
fse-agent-3.4.SMRNumber* fse-cli-admin-3.4.SMRNumber* \
fse-util-3.4.SMRNumber*
# fse --start
Starting omniORB Naming Service: [ OK ]
Starting FSE Service: [ OK ]
Starting FSE Resource Manager: [ OK ]
Starting FSE Management Interface: [ OK ]
Installing HSMFS Filter module: [ OK ]
Loading HSMFS Filter module: [ OK ]
Starting HSM FS Event Manager: [ OK ]
Mounting HSM File Systems: [ OK ]
Starting omniORB Naming Service: [ OK ]
Starting FSE Service: [ OK ]