Installation Manual

44 Installing FSE software
The bottom part of the output should match the following:
Starting FSE processes in a distributed or mixed FSE implementation
The general rule for starting the FSE system in a distributed or mixed implementation is to start the FSE
daemons (services) on the FSE server or the consolidated FSE system first, and start the FSE daemons
(services) on each external FSE client afterwards.
Step 1: Starting the FSE server
Proceed as follows:
1. To start the CORBA Naming Service daemon and the FSE daemons on the FSE server or the
consolidated FSE system, run the following command at local level:
The bottom part of the output should be similar to the following:
FSE server
Consolidated FSE system
Step 2: Starting FSE clients
Proceed as follows:
1. To start each of the external FSE clients connected to the already started FSE server or consolidated FSE
system, run the following command at local level:
The bottom part of the output should be similar to the following:
Starting omniORB Naming Service: [ OK ]
Starting FSE Service: [ OK ]
Starting FSE Resource Manager: [ OK ]
Starting FSE Management Interface: [ OK ]
Installing HSMFS Filter module: [ OK ]
Loading HSMFS Filter module: [ OK ]
Starting HSM FS Event Manager: [ OK ]
Mounting HSM File Systems: [ OK ]
# fse --start
Starting omniORB Naming Service: [ OK ]
Starting FSE Service: [ OK ]
Starting FSE Resource Manager: [ OK ]
Starting FSE Management Interface: [ OK ]
Starting omniORB Naming Service: [ OK ]
Starting FSE Service: [ OK ]
Starting FSE Resource Manager: [ OK ]
Starting FSE Management Interface: [ OK ]
Installing HSMFS Filter module: [ OK ]
Loading HSMFS Filter module: [ OK ]
Starting HSM FS Event Manager: [ OK ]
Mounting HSM File Systems: [ OK ]
# fse --start
Starting FSE Service: [ OK ]
Installing HSMFS Filter module: [ OK ]
Loading HSMFS Filter module: [ OK ]