Command Reference Guide

Chapter 1: Matrix Server Commands 4
Copyright © 1999-2006 PolyServe, Inc. All rights reserved.
lcl-dump – show information about LCL locks
Synopsis
/opt/polyserve/tools/lcl-dump
Description
This command should be run only at the request of PolyServe personnel.
log_collect – obtain log files
Synopsis
/opt/polyserve/tools/log_collect
Description
This command is used internally by the mxcollect utility and should not be
run directly.
mkpsfs – create a PSFS filesystem
Synopsis
/opt/polyserve/sbin/mkpsfs [-n <max-nodes>] [-l <label>]
[-o
[ enable-quotas,[userdefault=<size>],[groupdefault=<size>]]
[disable-fzbm] ] <device> [<size-in-blocks>]
Description
The mkpsfs command creates a PSFS filesystem on the specified device,
which must be imported into the matrix. PSFS filesystems use a block size of 4
KB.
device is a psd or psv device and is specified as follows:
• For a psd device partition, the device is specified as
/dev/psd/psdXXXpYY, where XXX is the drive number and YY is the
partition number. For example, /dev/psd/psd6p4 specifies partition 4 on
disk psd6.
• For a non-partitioned psd device, the device is specified as
/dev/psd/psdXXX, where XXX is the drive number. For example,
/dev/psd/psd5.