Command Reference Guide

Chapter 1: Matrix Server Commands 48
Copyright © 1999-2006 PolyServe, Inc. All rights reserved.
sandiskinfo – show SAN disk information
Synopsis
/opt/polyserve/bin/sandiskinfo [-i|-u|-v|-f] [-alr] [-U]
[--subdevices] [--dynvolumes] [- -dynvol_properties [volname]]
Description
The sandiskinfo command can display information for both imported and
unimported SAN disks and also for dynamic volumes. Under normal
operations, the sandiskinfo output should be the same on all servers in the
matrix.
Disk Information
With no options, sandiskinfo displays the UID, vendor, model, and capacity
of each imported disk and specifies the FC switch used to access the disk.
# sandiskinfo
Disk: /dev/psd/psd5
Uid: 20:00:00:04:cf:13:32:d1::0 SAN info: switch fcswitch port 7
Vendor: SEAGATE ST336704FC Capacity: 34732M
Following are the commonly used options for imported and unimported
disks:
sandiskinfo [-i|-u|-v|-f] [-alr] [-U] [-q]
The options are:
-i Display information for imported disks (the default).
-u Display information for unimported disks.
-v Display available volumes.
-f Display PSFS filesystem volumes.
-a Display all information; for -v, display all known volumes.
-l Additionally display host-local device name.
-r Additionally display local device route information.