User's Manual

Table 12 Disk drive loop IDs
Enclosure
ID
Bay
1
Bay
2
Bay
3
Bay
4
Bay
5
Bay
6
Bay
7
Bay
8
Bay
9
Bay
10
Bay
11
Bay
12
Bay
13
Bay
14
1
36 35
34
33 32 31 2E 2D 2C 2B
2A
29 27 26
2
51
4E 4D 4C 4B 4A 49 47 46 45 43
3C
3A
39
3
6A
69 67 66 65 63 5C
51
59 56
55
54
53 52
4
80 7C
7A
79 76
75
74
73 72
71
6E 6D 6C 6B
5
A5 A3
9F 9E 9D 9B 98 97 90 8F 88
84
82 81
6B6
B5
B4
B3 B2
B1
AE AD AC AB AA A9 A7 A6
15 D1
CE CD CC CB
CA
C9 C7 C6 C5 C3 BC
BA
B9
16
EF
E8
E4
E2
E1
E9 DC
DA
D9 D6
D5
D4
D3 D2
17
25 23
1F 1E 1D 1B
18
17
10 0F 08
04
02 01
Use ioscan –
fn to determine the device file (HBA number).
Example 2. ioscan –fn command
ioscan -fn
Class I H/W Path Driver S/W State H/W Type Description
=================================================================
fc 0 0/6/0/0 td CLAIMED INTERFACE HP Tachyon XL2 Fibre Channel Mass
Storage Adapter
/dev/td0
fc 1 0/6/2/0 fcd CLAIMED INTERFACE HP A6826-60001 2Gb Dual Port PCI/PCI-X
Fibre Channel Adapter (FC Port 1)
/dev/fcd1
fc 2 0/6/2/1 fcd CLAIMED INTERFACE HP A6826-60001 2Gb Dual Port PCI/PCI-X
Fibre Channel Adapter (FC Port 2)
/dev/fcd2
=========================================================================
Enter the fol
lowing command to allow HP-UX to ignore the disk authentication for the replacement disk.
fcmsutil /dev/device_file replace_dsk –l disk_loop_ID
For example, if you are replacing the disk drive installed in bay 5 in an enclosure with an ID 2
attached to HBA td1, enter:
fcmsutil /de
v/td1 replace_dsk -l 4B
IMPORTANT:
You must run the fcmsutil replace_dsk command on all HBAs that can access the disk drive.
CAUTION:
Spinning media can make the disk drive difficult to handle. To avoid damaging the disk drive, wait
approximately 30 seconds for the media to stop rotating before removing the drive from the enclosure.
To remove a disk drive:
1. Push the ejector button (Figure 34-1) and pull the release lever (Figure 34-2) down to the full
open position.
2500 Disk System user guide
61