User guide

Configuring the switch110
1. Select Configure > Ports.
The Configure Ports dialog box is displayed.
Figure 35 Configure Ports dialog box (Edge Switch 2/32)
Ports are numbered from 0 through 24 for the Edge Switch 2/24 and 0 through 31 for the Edge
Switch 2/32.
2. Click a Name box and type a name that reflects the end device connected through the port. For
example, use XYZ Server in which XYZ is the brand name of the server.
3. Block or unblock operation for a port by clicking the check box in the Blocked column. When
a check mark is displayed, the port is blocked.
Use one of the following options:
• For the Edge Switch 2/32 only, the 10-100 km column replaces the RX BB Credit
column. Enable or disable the extended distance buffering for the port by clicking a check
box in the 10-100 km column. When a check mark is displayed, extended distance
buffering is enabled.
• If a switch supports BB Credit, the RX BB Credit column replaces the 10-100km and sets
minimum and maximum allowable port BB credit values as follows:
a. Right-click in the RX-BB Credit column to display the RX BB Credits dialog box as shown in
Figure 36:
Figure 36 RX BB Credit dialog box