Manual

Configuring the director142
4. Click one of the following on the list under the Name field:
• Rx Throughput—An alert will occur if the threshold set for receive throughput is reached
• Tx Throughput—An alert will occur if the threshold set for transmit throughput is reached.
• Rx or Tx Throughput—An alert will occur if the threshold set for either receive or transmit
throughput is reached.
5. Click Next.
A new screen is displayed with additional parameters, as shown in Figure 62. The name
configured for the alert is displayed at the top of the screen.
NOTE: Click Previous if you need to return to the previous screen.
Figure 62 New Threshold Alerts dialog box–second screen
6. Enter a percentage from 1 through 100 for % utilization.
When throughput reaches this percentage of port capacity, a threshold alert will occur.
7. Enter the amount of cumulative minutes in which the % utilization should persist during the
notification interval before an alert is generated.
You can also click At any time if you want an alert to occur whenever the set % utilization is
reached. The valid range is from 1 to the interval value set in step 8.
8. Enter the interval in minutes in which throughput is measured and threshold notifications can
occur.
The valid range is 5 minutes to 70,560 minutes (7 weeks).