User's Manual

Operations 58
Keyword abbreviations
Several commonly used keywords in the HP SSA CLI have acceptable abbreviations, as shown in the
following table. For a complete list of abbreviations, enter help shorthand in the HP SSA CLI.
Keyword
Abbreviation in HP
SSA CLI
Keyword
Abbreviation in HP
SSA CLI
adapterid
ai nobatterywritecache nbwc
allunassigned
au numberparitygroups npg
arrayaccelerator
aa parallelscsi ps
cacheratio
cr physicaldrive pd
chassisname*
ch* postprompttimeout ppto
chassisserialnumber
csn preferredpathmode ppm
chassisslot
chs queuedepth qd
configurationmode
cm raid1writebuffering r1wb
connectionname
cn rebuildpriority rp
controller
ctrl redundantcontroller rc
ctrlpath
cp serialnumber sn
degradedperformancemode
dpo spareactivationmode sam
drivetype
dt ssdoverprovisioningoptimizat
ion
ssdopo
drivewritecache
dwc ssdphysicaldrive ssdpd
elevatorsort
es stripesize ss
enclosure
enc surfaceanalysiseventnotify saen
exitonerror
eoe surfacescandelay ssd
expandpriority
ep surfacescanmode ssm
inconsistencyrepairpolicy
irp sufacescanpriority sp
licensekey
lk tapedrive td
logicaldrive
ld waitforcacheroom wfcr
mnpdelay
mnpd — —
*The CLI also uses this keyword and abbreviation for the terms box name and RAID array ID.
The show command
The show command enables you to obtain information about a device.
Syntax:
<target> show [detail]|[status]
When you specify a target that consists of several devices, the information in the output is normally less
comprehensive than when you specify only one device as the target. You can use the [detail] parameter
in this case to retain all the information usually given for individual devices.
An extra parameter is available for controller targets: config. This parameter is used as follows:
<target controller> show config [detail]
If you use the config parameter, the output includes information about each device connected to the
controller.
Example 1:
=> ctrl slot=9 show